polycarb
Moderators: BeligerAnt, petec, administrator
polycarb
ok so basically at the allotment i found 2 sheets of polycarb (clear).
1 a square wich is around a meter by a meter if not more.
2 a rectangle meter by 2 meter (around that).
basically i dont need that much polycarb so if anyone is going to the aws in pontie i could bring it around.
sheet 1 £5
sheet 2 £10
1 a square wich is around a meter by a meter if not more.
2 a rectangle meter by 2 meter (around that).
basically i dont need that much polycarb so if anyone is going to the aws in pontie i could bring it around.
sheet 1 £5
sheet 2 £10
-
- Posts: 96
- Joined: Sat Oct 23, 2010 10:14 am
Re: polycarb
3mm or 4mm thick.
Re: polycarb
i'll take the rectangular sheet
Re: polycarb
Make sure its the industrial grade stuff though, the interior stuff that you get at Homebase and the like tends to crack really easily in combat.
"if it wasn't for Edison we'd be watching TV by candlelight"
Jack Orr
Team Orr Robotics
Jack Orr
Team Orr Robotics
Re: polycarb
that's because its acrylic that they sell there, as long as this polycarb is the real deal i'll take the rectangular sheet if harry's dad will let me take it back from pontefract in his car
Re: polycarb
Yes, however there is also a interior grade of polycarb that i believe either team storm or team mute used on their robot (i think it was storm 1 but cant be sure, i read it online ages ago) and the polycarb they were using shattered in their first fight and they found out it was because it was the interior spec stuff
"if it wasn't for Edison we'd be watching TV by candlelight"
Jack Orr
Team Orr Robotics
Jack Orr
Team Orr Robotics
Re: polycarb
well i'm planning on using it on a beetle so hopefully it'll be strong enough for that, thanks for the heads up about inferior polycarb aswell
Re: polycarb
ok
thatl
be as much as i put.
anyone for the square.
thanks team orr but this is the real stuff
thatl
be as much as i put.
anyone for the square.
thanks team orr but this is the real stuff
-
- Posts: 255
- Joined: Sun May 01, 2011 2:30 pm
- Location: Manchester
Re: polycarb
I have some diabond or something it's basically
0.3mm aluminium
2.4mm polycarb
0.3mm aluminium
All in one sheet (Y)
Would this be suitable for say a spinner? It seems pretty tough and would take a saw of somekind to cut
0.3mm aluminium
2.4mm polycarb
0.3mm aluminium
All in one sheet (Y)
Would this be suitable for say a spinner? It seems pretty tough and would take a saw of somekind to cut
I'm an optimist prime
Not a negatron
Not a negatron