Page 3 of 3
Re: Roboteering Fails
Posted: Wed Aug 03, 2011 9:37 pm
by Rhys
Had my worst injury from antweights last night, a burn off my soldering iron. It looked quite bad at the time (it went all white) but ran it under a cold tap and this morning it was fine. I really wish I had something more interesting to tell you....
Re: Roboteering Fails
Posted: Thu Aug 04, 2011 7:57 am
by haz
i burnt myself on a shorting battery yesterday, it actualy kind of cooked my skin becuse it had a litte flame on my right index finger then it started smoking, that hurt
Re: Roboteering Fails
Posted: Wed Mar 28, 2012 6:52 pm
by earthwormjim
Not that bad,but after grinding the front of Rim for an hour!,i decided to polish the surface.I had no idea it was that sharp. Twice too!
The top cut sliced in a good 5mm. Really sore today!
Re: Roboteering Fails
Posted: Wed Mar 28, 2012 7:26 pm
by joey_picus
Ouch Jim
the worst I have managed today is dropping a servo gear down the sink drain while modifying servos...
(can someone please remind me why I am legally allowed to possess servos?)
Re: Roboteering Fails
Posted: Wed Mar 28, 2012 7:47 pm
by earthwormjim
Joey wrote:Ouch Jim
the worst I have managed today is dropping a servo gear down the sink drain while modifying servos...
(can someone please remind me why I am legally allowed to possess servos?)
Ouch Joey. One question springs to mind...
Why were you dismantling servos over a sink!!!
Re: Roboteering Fails
Posted: Wed Mar 28, 2012 7:51 pm
by joey_picus
To be honest I'm not sure either ;P
Re: Roboteering Fails
Posted: Wed Mar 28, 2012 9:59 pm
by earthwormjim
Joey wrote:To be honest I'm not sure either ;P