Attaching wheels
Moderators: BeligerAnt, petec, administrator
-
- Posts: 3716
- Joined: Sun Apr 03, 2005 5:30 pm
- Location: Antrim, Northern Ireland
- Contact:
Attaching wheels
Any tips on attaching drive wheels to servos? Its the only bit I'm finding difficult. Cheers.
Die Gracefully Robotics
Winner - AWS 39
Winner - AWS 39
-
- Posts: 1134
- Joined: Tue Jan 20, 2004 12:00 am
- Location: London
- Contact:
There are loads of different ways to do this, firstly you could glue the servo horn to the wheel and then screw that on. If the wheel you are using has a bit out of the side that fits over the servo gear but keeps falling off you can drill a hole through this and the output gear and put a small pin through both. I am sure other people use different mothods.
TEAM GEEK!
- Simon Windisch
- Posts: 1806
- Joined: Tue Apr 15, 2003 12:00 am
- Location: Reading
- Contact:
- BeligerAnt
- Posts: 1872
- Joined: Wed May 15, 2002 12:00 am
- Location: Brighton
- Contact:
If using servos, then the best way is definitely to use the servo horns! (Unless you fancy making your own splined socket - I didn't think so!)
I usually glue the wheel to the servo horn, then drill some holes to match the ones in the horn and put some 1mm copper wire through like a staple and fix it in place with some hot-melt glue. This is a bomb-proof method if your wheels are made of something that is difficult to glue to.
Alternatively, if you can find some very small self-tapping screws, you can screw the wheel to the servo horn by screwing into the holes in the horn arms.
Centring the wheels on the horns (or vice-versa) can be tricky. Some horns have a raised ridge around the central hole. If you can drill a hole in the centre of your wheel that is the same size as the ridge it will give a means of location whilst you glue/pin/screw.
Don't forget you need a hole in the wheel anyway to get to the fixing screw for the servo horn! Don't rely on push-fitting the horns to the servos without screws. Too many people have lost a wheel (and hence a fight) this way.
I usually glue the wheel to the servo horn, then drill some holes to match the ones in the horn and put some 1mm copper wire through like a staple and fix it in place with some hot-melt glue. This is a bomb-proof method if your wheels are made of something that is difficult to glue to.
Alternatively, if you can find some very small self-tapping screws, you can screw the wheel to the servo horn by screwing into the holes in the horn arms.
Centring the wheels on the horns (or vice-versa) can be tricky. Some horns have a raised ridge around the central hole. If you can drill a hole in the centre of your wheel that is the same size as the ridge it will give a means of location whilst you glue/pin/screw.
Don't forget you need a hole in the wheel anyway to get to the fixing screw for the servo horn! Don't rely on push-fitting the horns to the servos without screws. Too many people have lost a wheel (and hence a fight) this way.
Gary, Team BeligerAnt
-
- Posts: 3716
- Joined: Sun Apr 03, 2005 5:30 pm
- Location: Antrim, Northern Ireland
- Contact: