MySolderIsOlder wrote: ↑Mon Mar 30, 2020 8:55 pm
Those are the ones I used for the Spin Twins. Lovely little motors but be careful not to run them stalled - the wires are rather thin!
(watch from about 1:14:24 of the AWS 61 YouTube vid for more details!)
Ahhh, will bear that in mind! lol. I dont think it looks to be easy to upgrade the wires on them ....
... where are my 7A ESCs Hobbyking?! Eh?
Doing some test 3D prints in PLA for the beetleweight frame. Have to make sure it all holds together and works, parts all fit inside etc.
Quite pleased with the finish and the dual extrusion support material works well
Bots:
DisinfectANT (Antweight), Cilit BANG (WIP Antweight), Kinetic Disassembly (WIP Antweight)
Got one of Mark's ESC receivers. The two PWM outputs are perfect for the two weapon motors on Kinetic Disassembly - so im now having a nightmare trying to wire this bot up and finish it .. i never leave enough room for wires. I need to start CADding wires into my designs..
Watch this space!
Bots:
DisinfectANT (Antweight), Cilit BANG (WIP Antweight), Kinetic Disassembly (WIP Antweight)
Drive works but first weapon motor is dead. Tried all channels. Going to have to dewire it and test the parts on their own, since I cant seem to find any reason why it isnt working.
Bots:
DisinfectANT (Antweight), Cilit BANG (WIP Antweight), Kinetic Disassembly (WIP Antweight)
Nope and no LEDs, which i thought there was on the 7A Turnigy esc. I checked the power wiring and it looked fine though. Cant remember if ESCs need a signal to come alive or not.
Damn, I suck at the electronics side of bots xD hope to get some time this weekend on it
Bots:
DisinfectANT (Antweight), Cilit BANG (WIP Antweight), Kinetic Disassembly (WIP Antweight)
will bear that in mind! lol. I dont think it looks to be easy to upgrade the wires on them .... 
and no LEDs, which i thought there was on the 7A Turnigy esc. I checked the power wiring and it looked fine though. Cant remember if ESCs need a signal to come alive or not.