deodorANT & friends

[haz]

hello people
starting to rebuild "if it aint broke break it" is now made of polycarbonate (6mm and 2mm so far) and im going brushless.
jonny: if you havent sold/used/eaten your brushless esc can you let me know?
i need to buy a new motor becuse the wires have got all tangled so i took 'em out to see what it looked like
picture of so far:
http://i947.photobucket.com/albums/ad31 ... 001-26.jpg

thanks for the wheels danny
i also need to get a disc made for this noting fancy, just a simple circle with two teeth, can anybody help?

[teamocean]

Send me a PM with what you are after- I might be able to help.

[Jonny]

looks good so far!, yes i've still got that esc lying around but i'm keeping it for another spinner of my own i'm afraid

[joey_picus]

The design does look good, quite simple and well laid out so far

[peterwaller]

Just a couple of points I wouldn't use copper wire for the front supports it is much too soft much better with piano wire.
Also I wouldn't just glue them onto the polycarb that is very difficult to bond to with any great strength I would drill into the plastic so they are a tight fit and then also glue them.
Otherwise a promising start.

[haz]

ok peter, what do you use? piano wire? where can i get some?
ok jonny, fair enough
ok will, pm about to be sent

[peterwaller]

Any model shop will sell it if not ebay:
http://www.ebay.co.uk/itm/Piano-Wire-Ca ... 61cc16a81d
I usually use about 1 to 1.5 mm diameter also very useful for flipper linkages.

[haz]

ok, thanks

[haz]

what is the lightest (and still fairly cheap) 11.1v lipo that could see a spinner through a fight or two?

thanks

[earthwormjim]

I got 3 single cell 350mah cells for a couple of dollars each for Raoul from hobbyking. So far they have exceeded expectations.
Cant get much cheaper.