deodorANT & friends

[Remote-Controlled Dave]

Put a regulator in and just run it straight off the RX

[haz]

hey spinner fans, guess what i got?
i got a new(ish) brushless setup for the new "if it aint broke, break it" just got it running, before you ask no its not paper armour its hdpe with a template glued to it (thanks for the tip jim )

http://www.youtube.com/watch?v=JDStK8zJA9U

[Team Orr]

what motors that?

[haz]

http://www.hobbyking.com/hobbyking/stor ... unner.html
but i got it 2nd hand from josh

[Remote-Controlled Dave]

Is the disc going to come off again?

[haz]

hopefully not, its bolted to the motor, anyway i have spun it up to fulland the disc din't come off




it did, however nick a wire and chewed up the brushless esc
and a drive servo
and a rx
lucky it threw the lipo clear!

[haz]

working again, yay
http://www.youtube.com/watch?v=T68CcuhxBbg

[Anoptimistprime]

any chance you could get some close up pics of how the weapon is fastened to the motor, i had one of these and i could never figure out how to fasten something to it

thanks

[haz]

8mm hole though disc, pushed onto the 8mm bit of the motor casing, then held on by the bolts

[Remote-Controlled Dave]

Looking good Haz, certainly an improvement on the old one. Looking forward to seeing it complete, and compete.