deodorANT & friends

[daliad100]

I'm assuming it cuts out when you spin up and when you turn off your weapon, it comes back on.

It's most likely current limiting on the bec kicking in so you need to hook up the positive lead of the servo board to the positive battery lead to stop the reciever from drawing too much current. It should give the spinner more oomph if you have a lipo.

[haz]

will it blow the rx? is there a diagram?

[daliad100]

It shouldn't.

If you attach your battery by the screw terminals on the sabertooth then you simply cut the red wire on the servo lead, strip the end and screw that into the positive battery terminal.

[haz]

thanks.
in other news my shapeways bits have just arived!!!

[haz]

going to need to file down some parts to make them fit

[josh]

Did the gears match up?

[haz]

not at the moment, but they will.....

[josh]

are you trying to file each individual tooth!?

[haz]

yep got some real tiny files, like needle thin, i have broken about 3 so far

[Rhys]

What did you get? Any pictures?