fleas

josh · Post by **josh** » Mon Jun 05, 2006 6:14 pm

DDB now has a body made from 0.5mm ali and i will do the electronics this week

http://i22.photobucket.com/albums/b330/ ... C01370.jpg

( DDB - devils drinking buddy)

Glenn Jones · Post by **Glenn Jones** » Sun Jan 06, 2008 3:52 pm

Who actually has a flea or is building one atm?

josh · Post by **josh** » Sun Jan 06, 2008 4:44 pm

ME! lol and joacim,pete,marco i think tim had one dave laurie had one umm think craig did as well cant remember who else

razerdave · Post by **razerdave** » Fri Apr 24, 2009 8:23 pm

I have 2 fleas, and I recently upgraded one:

Name: Little Devil
Wieght: 81g (need to shave a bit off

)
Power: 2 x 50:1Precision Micro drives on 6v, operated on servo boards
Battery: 200mAh lipo
Weapon: Servo operated Grade 2 Titainium lifting scoop
Notes: Quick!

Team Terror · Post by **Team Terror** » Sat Apr 25, 2009 4:08 pm

what about Divinity, Dave?

peterwaller · Post by **peterwaller** » Thu Aug 20, 2009 6:54 pm

I have just built a new flea called Deflea as in to rid the arena of fleas.
It is basically a scaled down version of Defiant .
Weight......75.2gms
Power.......2x 12v precision micro drive motorgearboxes need to upgrade to something faster.
Controller..OptionB63 board with AR6300 receiver
Battery......145mah lipo
Weapon.....0.25mm steel scoop front and back.
Notes........Very slow at the moment.
Normal way up:
http://i109.photobucket.com/albums/n66/ ... MG0785.jpg
Upside down:
http://i109.photobucket.com/albums/n66/ ... MG0787.jpg
The internals:
http://i109.photobucket.com/albums/n66/ ... MG0794.jpg
Along side Defiant:
http://i109.photobucket.com/albums/n66/ ... MG0790.jpg
Pushing Defiant:
http://s109.photobucket.com/albums/n66/ ... MG0798.flv

Andrew_Hibberd · Post by **Andrew_Hibberd** » Thu Aug 20, 2009 8:49 pm

will fleabite be ressurected?

razerdave · Post by **razerdave** » Thu Aug 20, 2009 9:39 pm

The servo I have for LD has packed in YET AGAIN, so I was hoping to use a Spektrum servo like Pete uses in Variant's lifter, but I was wondering what it runs on ?

Also, I was going to use an Option A board for LD because it may save me the weight to have the servo installed

peterwaller · Post by **peterwaller** » Fri Aug 21, 2009 7:04 am

Andrew it might well be if only for sentimental reasons as it is only a new servo horn on one side and glue the balsa chassis back together. At the moment I have 10 Ants and that would make two fleas plus three minisumo's and a micromouse wallfollower so I don't really need any more.
Dave the spec for the spektrum SPMS75 servo says 3.2 - 6.0 V.
Variant uses two, one for each lifting tine.

razerdave · Post by **razerdave** » Fri Aug 21, 2009 1:28 pm

are yours powered by 5v or 6v ? I dunno how your board is set up