Peter Wallers Fleas

All things small and scratchy.

Moderators: administrator, BeligerAnt, petec

Post Reply
Rapidrory
Posts: 1160
Joined: Sun Nov 24, 2013 9:54 pm

Re: Peter Wallers Fleas

Post by Rapidrory » Wed Oct 14, 2015 7:18 pm

Don't worry Dan, just rebuilding 'Moon which has the same spinner mech from the old Why Wait :L What ESC are you using in Fleabite? I'm trying to switch most of my ants over to the new 12A Afro ESCs, since they're cheap and run SimonK firmware (basically the best there is), so hopefully none of mine should suffer spin up issues after that..
Rory Mangles - Team Nuts

Robots: Nuts 2 and many more...

NanoTwo Motor Controllers: https://nutsandbots.co.uk/product/nanotwodualesc

User avatar
peterwaller
Posts: 3709
Joined: Fri Feb 15, 2002 12:00 am
Location: Aylesbury Bucks
Contact:

Re: Peter Wallers Fleas

Post by peterwaller » Thu Oct 15, 2015 8:27 am

It is not really a full ant size motor just a bit beefier than the old ones its a C2024.
http://www.hobbyking.com/hobbyking/stor ... ouse_.html
As to the controller it will be the biggest one I can get in the size and weight.
The old one was a Plush 6 I have a few from a YEP7 though a plush 10 upto a YEP18.
I was looking at the Afro 12A but not quite sure what they meant by multi-rotor specific firmware.

User avatar
Shakey
Posts: 1096
Joined: Sat Mar 13, 2010 8:38 pm
Location: Reading

Re: Peter Wallers Fleas

Post by Shakey » Thu Oct 15, 2015 8:28 am

It's actually a slightly larger version of what I used to run in HSOD.
Nuts And Bots - For all your components and ready built antweights!

Alex Shakespeare - Team Shakey / Nuts And Bots / Team Nuts:
AWS 44, 45, 49, 51 & 55 Winner - Far too many robots!

User avatar
peterwaller
Posts: 3709
Joined: Fri Feb 15, 2002 12:00 am
Location: Aylesbury Bucks
Contact:

Re: Peter Wallers Fleas

Post by peterwaller » Thu Oct 15, 2015 9:43 am

I have ordered a couple of the Afro 12A to try has anyone tried running the small motors from the little double gearboxes on 3 cells.

User avatar
Shakey
Posts: 1096
Joined: Sat Mar 13, 2010 8:38 pm
Location: Reading

Re: Peter Wallers Fleas

Post by Shakey » Thu Oct 15, 2015 10:30 am

It would end very very badly, they don't cope well at 2S under load. And just out of interest I connected one to a 3S with no gearbox... it didn't go well.
Nuts And Bots - For all your components and ready built antweights!

Alex Shakespeare - Team Shakey / Nuts And Bots / Team Nuts:
AWS 44, 45, 49, 51 & 55 Winner - Far too many robots!

User avatar
peterwaller
Posts: 3709
Joined: Fri Feb 15, 2002 12:00 am
Location: Aylesbury Bucks
Contact:

Re: Peter Wallers Fleas

Post by peterwaller » Thu Oct 15, 2015 10:50 am

Cheers for that I will skip that idea or at least make sure the drive to the gear motors is not 3 cell.
Here is what I have so far.
Image

Image
Last edited by peterwaller on Fri Jul 21, 2017 7:26 pm, edited 1 time in total.

Rapidrory
Posts: 1160
Joined: Sun Nov 24, 2013 9:54 pm

Re: Peter Wallers Fleas

Post by Rapidrory » Thu Oct 15, 2015 12:47 pm

That's basically a properly built version of Moon; same spinner motor, same drive units, same layout... Just your one will work :L

3s sounds a bit overkill; I've always just run that brushless on 2s and it's never been short of power. Plus considering moon only had 10g spare for chassis, I'd be surprised if you had the weight for a 3s.

As for the drive units, for running them on 2s I just wound the travel adjust down to 30% and it was fine, (when the signals mix it takes it to 60% max). I'm looking at doing a firmware mod on my ESCs that hard limits the output to 50% so those drive units can be run on 2s without travel adjust or fire :L
Rory Mangles - Team Nuts

Robots: Nuts 2 and many more...

NanoTwo Motor Controllers: https://nutsandbots.co.uk/product/nanotwodualesc

Hogi
Posts: 1002
Joined: Sun Dec 30, 2012 6:47 pm
Location: basingstoke

Re: Peter Wallers Fleas

Post by Hogi » Fri Oct 16, 2015 6:11 am

the new fleabite looks awesome Peter. :)
Daniel Jackson.

Team Hectic.

Many antweights

Super antweights: territorial.

Fleaweights: fleadom fighter, gaztons.

Featherweights: hectic (under construction)

User avatar
peterwaller
Posts: 3709
Joined: Fri Feb 15, 2002 12:00 am
Location: Aylesbury Bucks
Contact:

Re: Peter Wallers Fleas

Post by peterwaller » Mon Oct 19, 2015 8:59 am

Cheers Dan if looking the part was all that was needed my robots would probably do better than they do.
I have been experiencing some jamming problems with my gearboxes so have had to go through another iteration of the chassis and wheel design.
Here is the final robot the lighter drive units mean I was able to have a lid this time and upgrade the polycarb from 0.75 to 1.5 mm.
Not sure about the blue tyers though. :oops:
Image

Image
Last edited by peterwaller on Fri Jul 21, 2017 7:28 pm, edited 1 time in total.

Hogi
Posts: 1002
Joined: Sun Dec 30, 2012 6:47 pm
Location: basingstoke

Re: Peter Wallers Fleas

Post by Hogi » Mon Oct 19, 2015 5:39 pm

i'm liking the blue tyres too :)
Daniel Jackson.

Team Hectic.

Many antweights

Super antweights: territorial.

Fleaweights: fleadom fighter, gaztons.

Featherweights: hectic (under construction)

Post Reply