Places to spend cash or learn things!
Moderators: administrator, BeligerAnt, petec
-
Shakey
- Posts: 1083
- Joined: Sat Mar 13, 2010 8:38 pm
- Location: Reading
Post
by Shakey » Fri Nov 03, 2017 5:51 pm
Hi Roboteers,
I'm launching Nuts And Bots.
A webstore selling my wide variety of parts and ready to run robots. While my main focus is in antweights, I have and plan to add products for the larger weight classes.
Currently sporting 3 different antweights, a range of ant parts and my ever in demand Argos Drill Mounts.
Thankyou,
Alex
https://nutsandbots.co.uk
-
Shakey
- Posts: 1083
- Joined: Sat Mar 13, 2010 8:38 pm
- Location: Reading
Post
by Shakey » Mon Mar 12, 2018 6:42 pm
10 more V3's into the wild!
-
Shakey
- Posts: 1083
- Joined: Sat Mar 13, 2010 8:38 pm
- Location: Reading
Post
by Shakey » Sun May 06, 2018 4:25 pm
I have some more V3's! I will put the stock live at 6pm.
Motors are also in stock!
-
EddieJ
- Posts: 81
- Joined: Sun Apr 08, 2018 2:11 pm
- Location: Dorset
Post
by EddieJ » Mon May 07, 2018 5:16 pm
Wait, did they sell out already

?
Bots:
DisinfectANT (Antweight), Cilit BANG (WIP Antweight)
-
Shakey
- Posts: 1083
- Joined: Sat Mar 13, 2010 8:38 pm
- Location: Reading
Post
by Shakey » Mon May 07, 2018 10:10 pm
Yeah, that batch moved slowly by comparison clocking 3 hours 20 mins of being in stock. :S The demand is a bit ridiculous to keep up with!
-
EddieJ
- Posts: 81
- Joined: Sun Apr 08, 2018 2:11 pm
- Location: Dorset
Post
by EddieJ » Mon May 07, 2018 10:31 pm
Gah, I better hold out for the next round of stock then.
Until the next restock ill proxy in a Dasmikro ESC

.. then when it dies on me, switch to one of these later xD
Bots:
DisinfectANT (Antweight), Cilit BANG (WIP Antweight)
-
Shakey
- Posts: 1083
- Joined: Sat Mar 13, 2010 8:38 pm
- Location: Reading
Post
by Shakey » Fri Jun 28, 2019 3:41 pm
The New NanoTwo LT is now stocked:
https://nutsandbots.co.uk/product/nanotwo-lt-dual-esc/
This ESC is a receiverless version of the reliable and competitive NanoTwo V2.
Wheels
Just a minor note that this afternoon I managed to solve a quality issue that was causing prints to be a bit rougher (No affect on strength or function) and a higher failure rate in production. I have now fixed this resulting in a much nicer finish and with a far better production rate to get through orders faster.