AntWeight Parts Online & Offline

Simon Windisch · Post by **Simon Windisch** » Tue May 17, 2005 7:32 pm

Try this http://www.strikalite.co.uk/prodcat_typ ... er_Pack/5/ althought you will also have to buy a battery lead, perhaps http://www.sussex-model-centre.co.uk/Ra ... s-1321.htm

I have used these batteries now and they're fine.

Simon

Andrew_Hibberd · Post by **Andrew_Hibberd** » Fri May 27, 2005 9:51 pm

http://www.jperkinsdistribution.co.uk/l ... s/Chargers

This web site has the cheap automatic lipo chargers at the bottom

Andrew_Hibberd · Post by **Andrew_Hibberd** » Sat Aug 20, 2005 5:06 pm

Techno bots do a great lipo charger. part 1072-001

Microproceesor controlled 1-4 cell LiPo charger

Features:

* Constant current / constant voltage charger method
* Automatic charge current setting - 3.0A max
* Reverse polarity protection on both input & output
* 12V nominal input

Just need a power supply, i currently use a computer PSU which gives about 17A at 12V. But maplin do a 1A supply which is easier to use. Both are about ?10

josh · Post by **josh** » Sun Sep 11, 2005 3:32 pm

were in england can i get parts for a pneumatic flipper

Rhys · Post by **Rhys** » Mon Sep 12, 2005 12:37 am

Well from your other post I'm guessing you'll need a switch for the system and a tank. You can't buy a switch new anymore, but there's one going for ?1 on ebay!

Ebay Switch

And for the tank, I find these work fine.

Breath Sprays

They are 11ml, so you can't get loads of air in them, but they'll fit in an ant no problem. You'll get about 6 flips from one of these by fillling it with the standard lego pump (about 40psi apparently). If you pump it to 100psi, you should get a good deal more. You can connect them up too to get more flips.

olivers · Post by **olivers** » Wed Sep 21, 2005 7:02 pm

Hi Cap Lipo

http://www.flightpower.co.uk/products.php?id=23

Simon Windisch · Post by **Simon Windisch** » Tue Jan 10, 2006 12:05 am

Hi there,

Overlander have stopped stocking 145mAh batteries (9 gram). The only UK supplier seems to be http://www.aurorra.co.uk/shop/2/index.htm but they are massively expensive at ?15.81 including postage and VAT.

I'm buying three from http://www.robotmarketplace.com/marketp ... ly-ko.html and they should be ?29.11 including postage.

Simon

Rhys · Post by **Rhys** » Tue Jan 10, 2006 1:12 am

They have them Here for ?10.60 with free P&P.

olivers · Post by **olivers** » Sat Jan 14, 2006 1:18 pm

Does anyone know a good place to get polycarb offcuts?

I'm after something I can put a thread in so 8mm+ Need bits about 6" square.

Technobots do bits about 600*500mm but they are a bit expensive when I can hopefully get offcuts cheaper.

Andrew_Hibberd · Post by **Andrew_Hibberd** » Sat Jan 14, 2006 4:36 pm

Post on the fighting robots forum, most feather/heavy builders will have some lying arround.