closest experience i have is fixing zx spectrums.. after the modulator bypass, the next job was always to replace the voltage regulator, as the old ones were incredibly inefficient. if you remember the 128k 'toastrack', that whole 6 inch heatsink was for the voltage regulator, dropping 9v to 5v!
that probably doesn't help, does it? I'm probably just showing my age. :p
Things getting hot.
Moderators: BeligerAnt, petec, administrator
Re: Things getting hot.
Team BLEEP Suspicious Houmous / Sprouting Potato / Fermented Melon / Black Carrot
-
- Posts: 227
- Joined: Sun Dec 10, 2017 4:39 pm
Re: Things getting hot.
I’m using this Rx https://hobbyking.com/en_us/turnigy-ia6 ... eiver.htmlGeorgeR wrote: ↑Sat Mar 03, 2018 6:23 pm The fingertech is a good quality esc, and I'm sure it can handle the voltage. My initial hunch is that you might be drawing too much current on the bec line.
What was the full setup? So which receiver were you using and did you have any other esc's or servos attached?
N20 motor, 3s 180mah galaxy lipo tiny esc and that Rx.
No servo or other esc.
I didn’t know what a voltage regulator was voorsk untill I started building robots. Haha!
-
- Posts: 227
- Joined: Sun Dec 10, 2017 4:39 pm
Re: Things getting hot.
I think i managed to hook up the multimeter to check the current draw to the Rx.
It registered 0.15A the esc BEC says it can handle 0.1.
I’ve ordered a micro BEC that can handle 1A which cost £2.50! I can do some testing and hopefully that will solve the over heating problem.
It registered 0.15A the esc BEC says it can handle 0.1.
I’ve ordered a micro BEC that can handle 1A which cost £2.50! I can do some testing and hopefully that will solve the over heating problem.
Re: Things getting hot.
Looks like you found the problem, the specs on that receiver say it should draw 30mA (0.03A), so it seems its pulling a lot more power than it should. Also the fingertech bec is actually only rated at 40mA with a 12v supply (100mA is for less than 8V) so it would definitely get hot running 150mA.
The separate 1A because should solve your problems, just remember to disconnect the bec wire from the fingertech.
The separate 1A because should solve your problems, just remember to disconnect the bec wire from the fingertech.
Team Zero - AWS 58 Champion!
Zero - rambot - - Axiom - axebot - - Valkyrie - drum spinner
Blueprint - rambot - - Vampire - horizontal spinner - - Particle - ???
RBMK - quad spinner gyro walker - - Duality - dual spinner gyro walker
Zero - rambot - - Axiom - axebot - - Valkyrie - drum spinner
Blueprint - rambot - - Vampire - horizontal spinner - - Particle - ???
RBMK - quad spinner gyro walker - - Duality - dual spinner gyro walker
-
- Posts: 227
- Joined: Sun Dec 10, 2017 4:39 pm
Re: Things getting hot.
Ahhh I was wondering what the graph meant. Seems the Rx could be faulty. I have a second one. I’ll test it to see what it’s current draw is.
**EDIT**
Tested second RX. This one is pulling 0.06A. Even that is too much.
Thanks for the help everyone. I enjoyed the problem solving but couldn’t have done it with out this forum.
Paul
**EDIT**
Tested second RX. This one is pulling 0.06A. Even that is too much.
Thanks for the help everyone. I enjoyed the problem solving but couldn’t have done it with out this forum.
Paul