https://www.amazon.co.uk/gp/aw/d/B00EE9 ... ref=plSrch
This stuff is only 1.5m thick, can't be too heavy. Would layering on top of polycarbonate with this be useful? Or would it just end up being little shreds of rubber everywhere?
Is this stuff any good?
Moderators: BeligerAnt, petec, administrator
-
- Posts: 135
- Joined: Thu Dec 07, 2017 9:32 pm
Is this stuff any good?
My robots:
Third Law (antweight) - push/ram bot
Manticore (antweight) - hammer bot
Third Law (antweight) - push/ram bot
Manticore (antweight) - hammer bot
Re: Is this stuff any good?
I use this type of tape to insulate my 3d printer. I can't see it really being very effective armouring from spinners. It yields easily and would just shred.
Nuts And Bots - For all your components and ready built antweights!
Alex Shakespeare - Team Shakey / Nuts And Bots / Team Nuts:
AWS 44, 45, 49, 51 & 55 Winner - Far too many robots!
Alex Shakespeare - Team Shakey / Nuts And Bots / Team Nuts:
AWS 44, 45, 49, 51 & 55 Winner - Far too many robots!
-
- Posts: 135
- Joined: Thu Dec 07, 2017 9:32 pm
Re: Is this stuff any good?
Yeah, fair enough, figured there was probably a reason I'd not seen any pictures that looked to use it.
My robots:
Third Law (antweight) - push/ram bot
Manticore (antweight) - hammer bot
Third Law (antweight) - push/ram bot
Manticore (antweight) - hammer bot