Spektrum DX6 Mixing

[AntRoboteer]

Right, to enable mixing, go into the mixing settings and change the settings of P-Mix 1 and 2 to the settings in the pictures attached. Make sure both of your servos or ESC leads are on either Elevator or aileron on the receiver. Then reverse any channels that you need to to get it to drive properly and there you have it. You can also change percentages and levels in the Dual Rate and Exponent settings.

Hope this helps!

[engr]

Thanks for that I will give it a go tomorrow!

[AntRoboteer]

Hope it works out for you!

[Remote-Controlled Dave]

Ah, I assumed that was Defiant as Peter entered it. Cool. Bring them back!