RobotWars101

After a little research it seems I didn't actually have to solder both red and black cables for 2 RX cables. Maybe my white cables are touching and messing up the signal.

Hello, Purchased a dasmikro and had a go soldering it. It was very difficult to get the wires to stick on. Managed it all in the end... However after connecting the motors, battery and RX. The motors don't work. The power supply is working as the light comes on the RX but moving the control sticks t...

Super cheap as well. £1 a servo with postage. If I'm not wrong?

Description mentions about massive dead space.
Pity I will have to wait 20 days for it to arrive in the post.

Thanks for the help everyone.

https://www.robotshop.com/uk/9g-continu ... gJ7HvD_BwE

These servo have built in dead space. Have you used these before?

Potentially I may have damaged my persistent turning servo with over heating. Now it over heats very quickly. Thus causing it to need trimming constantly.

Are cheap servos a fast turn over?

Thanks
Paul

Ah thanks shakey. Ultimately very annoying this issue. So having a thick layer of glue under the servo is not going to help things. When people are battling their bots are they constantly trimming during the fight? Or do none servo ESC take longer to heat up and cause less problems? Thanks again for...

Hello, I am new to building robots. I've done a lot of back ground reading but seem to have got a little stuck. I've started with a simple set up card board chassis glue gunned together. Then Using two continuous servos connected into a receiver and battery. I bought a cheap 4 channel transmitter. M...